Standing seam and metal panel roofing, roof repair and full replacement in Greenville. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Greenville.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
A coating buys real years on the right roof and wastes money on the wrong one. We will tell you honestly which kind you are looking at.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Greenville homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Greenville home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Greenville homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
No. Estimates are always free in Greenville. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Yes. Gutters, guards, soffit and fascia are all part of keeping the edge of a Greenville roof dry, so we handle them along with the roof instead of sending you off to find somebody else to finish the job.
Sometimes. If the decking is sound and there is only one layer of shingles, a Greenville metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Greenville houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Much less than people expect. Over solid decking with underlayment under it, a Greenville metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
A metal roof installed properly on a Greenville home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
Real feedback from homeowners whose roofs we have worked on.
"Tore off two layers of old shingles and found rotten decking underneath. They showed me the boards, told me what the change would cost, and let me decide before going ahead."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Our crews cover the surrounding area, not only the city limits.